Seeking Help Compiling Marlin Firmware for Anet A8 with Tatara Frame and SKR 1.4 Turbo

[raffaeletavolieri]

Seeking Help Compiling Marlin Firmware for Anet A8 with Tatara Frame and SKR 1.4 Turbo

Hello everyone,
I'm reaching out for assistance in compiling the Marlin firmware for my upgraded Anet A8 with a Tatara frame. I've also integrated a BigTreeTech SKR 1.4 Turbo board and several other components. Here's a breakdown of my setup:

• Motherboard: BigTreeTech SKR 1.4 Turbo
• Display: BigTreeTech TFT70 V3.0
• Endstops: Mechanical for X and Y, BLTouch for Z
• Thermistors: 100k for both the hotend and bed
• Extruder: Dual Drive Bowden System
• Stepper Motors: TMC2130 in SPI mode
• Axis Configuration: Dual motor for the Z-axis
  I'm encountering some challenges in the firmware compilation and configuration, particularly regarding [specify the issues you're facing, e.g., "BLTouch setup", "motor calibration", etc.].
  Additionally, I'd appreciate if anyone could guide me on the correct wiring for the stepper motors. I'm unsure about the correct sequence of the wire colors and how to properly connect them to the SKR board.
  If anyone has insights or advice on setting up these specific components with Marlin, I'd be deeply grateful for any guidance.
  Thank you so much in advance!