This section describes how the CLI works. These steps are performed by the CLI.
For additional information see the decision tree of the deploy command.
The first step of the deploy process is validation. As part of that validation the CLI verifies if there are changes in either manifest, release or stemcell. In case there are no changes CLI will exit early with message Skipping deploy.
As part of manifest validation the CLI validates manifest properties and parses manifest for deploy. The CLI parses the deployment manifest into two parts: the deployment manifest, and the CPI configuration.
The deployment manifest is used arbitrary releases onto a single VM. The deployment manifest is defined by the networks, resource_pools, disk_pools, and jobs sections of the manifest. Currently only one job is allowed to be specified since the CLI will only create single VM.
The CPI configuration is used to install and configure the CPI locally. It is constructed from the cloud_provider section of the manifest.
The provided CPI release is compiled on the machine where bosh-init is run, and is used locally to run the CPI commands necessary to create the VM.
The CPI release must contain a job specified by the cloud_provider.template.job. During CPI installation, all the packages that the CPI job depends on will be compiled and their templates rendered. CPI job templates have access to properties defined in the cloud_provider -> properties section of the manifest.
The compiled packages and rendered job templates are stored in a ~/.bosh/<installation_id> folder for each deployment.
After the CPI is installed locally, the CLI calls the create_stemcell CPI method with the provided stemcell.
In case the VM was previosly deployed, the CLI tries to connect to the agent on the existing VM. If the agent is responsive, the CLI stops services that are running on that VM and unmounts all disks that are attached to the VM. Eventually, the CLI deletes the existing VM and removes VM CID from deployment state file.
Next, the CLI sends the create_vm command to the CPI with the properties parsed from the manifest. Additionally, the VM CID is persisted in deployment state file in the same folder as the deployment manifest.
The CLI creates a reverse SSH tunnel to the BOSH VM using the properties provided in the manifest. This allows the agent on the VM to access the machine where bosh-init deploy was run.
Once the SSH tunnel is up the CLI uses the provided mbus URL to issue ping messages to the agent on the BOSH VM. Once the agent is ready it will respond to the ping.
The CLI will create and attach a disk to the VM if it is requested in the deployment manifest. There are two ways to request the disk:
- Adding the
persistent_disk_poolproperty on a job which references the disk pool in the list ofdisk_poolsspecified on the top level of the manifest. - Adding the
persistent_diskproperty which specifies the size of persistent disk.
You should use disk_pools if you want to use disk cloud_properties.
In this case, the CLI calls the create_disk CPI method with the provided size. Additionally, the disk CID is persisted in deployment state file.
After the disk is created, the CLI calls the attach_disk CPI method. After the disk is attached, the CLI issues a mount_disk request to the agent on the BOSH VM.
Once the agent is listening on the mbus URL, the CLI sends a stop message to the agent. The agent is using monit to manage job states on VM. The stop is a preparation for the subsequent job update.
Next the CLI sends an apply message with the list of packages and jobs that should be installed on the VM. The agent serves a blobstore at <mbus URL>/blobs endpoint.
For each of the templates specified, the CLI downloads the corresponding job template from the blobstore, renders the template with the properties specified for the job in the deployment manifest. Once all the templates are rendered, the CLI uploads the archive of all the rendered templates to the blobstore and generates an apply message. This apply message contains the list of all packages, spec of the templates archive with uploaded blob ID, networks spec parsed from deployment manifest and configuration hash which is a digest of all rendered job template files.
Once the apply task is finished the CLI sends a start message to the agent which starts installed jobs.