This repo consists the codes required for the microbits used to build the minibot at the Coder Girls 2018 workshop. A video into the making of this bot can be found below:
This git repo is part of the Coder Girls Initiative 2018 organized by Naya in Kathmandu, Nepal.
In this project we use one sender micro:bit that sends gesture information over to another receiver micro:bit through radio. The receiver micro:bit then uses the gesture info to control dc motors and thus moving the minibot.
List of items required:
- 2 x Micro:bits - 1 receiver and 1 sender
- 1 x Microbit Edge Connector
- 1 x L298N Motor Driver
- Female/Female Jumper Wires
- 6 x AA Batteries (or 8 if you need more speed)
- 1 battery holder accomodating 2 AA batteries
- 1 battery holder accomodating 4 (or 6) AA batteries
- 2 x caster wheels
- 2 x Motor and wheel set
- Double Sided Tape
- 1 x Box
- 4 x M3x25mm screws
- Screw Driver
Wire connections for the Minibot (Between receiver Micro:bit and motor driver):
