From 1e620fdcba573d5ebb9702f9fc01d6f2b1432991 Mon Sep 17 00:00:00 2001 From: yellobello Date: Sun, 2 Jun 2019 16:49:18 +0200 Subject: [PATCH] Update step06.md Added tee nuts for psu and einsy board --- full_upgrade/for_mk2.5/manual/assembly_instructions/step06.md | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) diff --git a/full_upgrade/for_mk2.5/manual/assembly_instructions/step06.md b/full_upgrade/for_mk2.5/manual/assembly_instructions/step06.md index 20bbcaea..1d53d278 100644 --- a/full_upgrade/for_mk2.5/manual/assembly_instructions/step06.md +++ b/full_upgrade/for_mk2.5/manual/assembly_instructions/step06.md @@ -10,7 +10,7 @@ * 2x 356mm v-slots * 6x 90° joining plates * 18x M5x10mm screws -* 18x Tee nuts +* 23x Tee nuts #### Assembly @@ -19,6 +19,7 @@ 1. Check all dimensions as seen on figure 6.3
:warning: this step is very important, double check everything is perfectly square 1. File **all** sharp edges of 4x latest 90° joining plates (not only diagonals) (figure 6.1). A small chamfer is enough, this just to avoid scratching cables and it will be useful for the next step as well +1. Insert 3 tee nuts on one side for future assembly of the power supply (Step 15) and 2 tee nuts on the other side of the frame for future assembly of the einsy board (Step 16) 1. Assemble the 4x latest 90° joining plates as seen on figure 6.4. :warning: Make sure the tapped holes at the end of the 356mm extrusions are on top