Original source code was posted here:
http://www.dd-wrt.com/phpBB2/viewtopic.php?p=435578&sid=0c7c7b114dc7239be2620514cecbe2d8
I had fucked up the dd-wrt installation, forgetting to set nvram version to three, that caused the reset button not to work. That combined to bad configuration on WAP port i had the box unreachable. The only way to reset the box to factory defaults was to use jtag connection.
- Arduino: duemilanove/atmega 328 - worked out of the box, except that i had to retry the launch few times before "reseting arduino" went ok.
- OS: Ubunutu 14.04.3 / 3.15.0-031500rc2
- Target: WAP54G 3.1, running dd-wrt v24 - image on dd-wrt wiki page is from older version, same pins worked though.
- Command:
./tjtag -erase:nvram /wiggler /noreset - Notes: It did not work without
/wiggle /noreset. Chip identification worked fine.
- See a similar project using UrJTAG (available for Linux, OSX, or Windows) and an Arduino: https://github.com/zoobab/urjtag_arduiggler
- See also JTAGduino: https://github.com/balau/JTAGduino
- See also FUJI: http://hsbp.org/fuji