Version two includes code refactoring, and bug fixes. I have also fixed up the STL models.
- Added encoder knob model for printing
- Cleaned up SCAD Code
- The print time has been reduced by about half
- Removed the screw holes (Lid snaps on now)
- Made the roof/floor less thick
- Removed extra lip around encoder knob hole
- Arduino fits better
- Pressure sensor fits better, USB and power jack holes removed, as they are not used in the case.
Software and hardware for Arduino-based orgasm prediction / detection ... on protoboard!
The nogasm is an amazing toy. I wanted to make something easier to hack and more accessible to the homebuilder. Fortunately headcrabned was kind enough to open source the whole thing.
I ported it the Arduino Uno, and hacked around on perfboard until I had it working. It works great and only requires a handful of readily available through-hole components.
Some aspects have been simplified compared to the original electronics:
- The DIP switches have been eliminated. Options are configured in the source instead.
- The RGB backlit rotary encoder has been replaced with a more common unlit one. The mode is still visible on the LED ring.
- It has more LEDs! NeoPixel Rings with 24 LEDs are the right size for the project.
-
Flash the Arduino with the Protogasm VII Code
-
TODO Setup the plug
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International Licence, available at http://creativecommons.org/licenses/by-nc/4.0/.