More minor improvements

imnotnoa · Sep 30, 2020 · 316d297 · 316d297
1 parent 8130ccc
commit 316d297
Showing 1 changed file with 4 additions and 4 deletions.
diff --git a/Marlin/Configuration_adv.h b/Marlin/Configuration_adv.h
@@ -760,7 +760,7 @@
 
   // On a 300mm bed a 5% grade would give a misalignment of ~1.5cm
   #define G34_MAX_GRADE              5    // (%) Maximum incline that G34 will handle
-  #define Z_STEPPER_ALIGN_ITERATIONS 5    // Number of iterations to apply during alignment
+  #define Z_STEPPER_ALIGN_ITERATIONS 3    // Number of iterations to apply during alignment
   #define Z_STEPPER_ALIGN_ACC        0.02 // Stop iterating early if the accuracy is better than this
   #define RESTORE_LEVELING_AFTER_G34      // Restore leveling after G34 is done?
   // After G34, re-home Z (G28 Z) or just calculate it from the last probe heights?
@@ -1131,7 +1131,7 @@
   // Enable this option and set to HIGH if your SD cards are incorrectly detected.
   //#define SD_DETECT_STATE HIGH
 
-  #define SDCARD_READONLY                   // Read-only SD card (to save over 2K of flash)
+  //#define SDCARD_READONLY                   // Read-only SD card (to save over 2K of flash)
 
   #define SD_PROCEDURE_DEPTH 1              // Increase if you need more nested M32 calls
 
@@ -2091,8 +2091,8 @@
   #define FILAMENT_CHANGE_ALERT_BEEPS         10  // Number of alert beeps to play when a response is needed.
   #define PAUSE_PARK_NO_STEPPER_TIMEOUT           // Enable for XYZ steppers to stay powered on during filament change.
 
-  #define PARK_HEAD_ON_PAUSE                    // Park the nozzle during pause and filament change.
-  #define HOME_BEFORE_FILAMENT_CHANGE           // If needed, home before parking for filament change
+  //#define PARK_HEAD_ON_PAUSE                    // Park the nozzle during pause and filament change.
+  //#define HOME_BEFORE_FILAMENT_CHANGE           // If needed, home before parking for filament change
 
   #define FILAMENT_LOAD_UNLOAD_GCODES           // Add M701/M702 Load/Unload G-codes, plus Load/Unload in the LCD Prepare menu.
   //#define FILAMENT_UNLOAD_ALL_EXTRUDERS         // Allow M702 to unload all extruders above a minimum target temp (as set by M302)