UGV SDK

Introduction

This software package provides a C++ interface to communicate with the mobile platforms from Weston Robot and AgileX Robotics, for sending commands to the robot and receiving the latest robot state. The repository is a joint effort by the development teams at Weston Robot (Singapore) and AgileX Robotics (China).

• Copyright (c) 2020-2021 Weston Robot
• Copyright (c) 2020-2021 AgileX Robotics

Please create an issue on Github at https://github.com/westonrobot/ugv_sdk/issues if you encounter any problems when using the packages.

Supported robot platforms

• Scout
• Scout Mini
• Hunter
• Tracer
• Bunker
• Ranger Mini

Supported environments

• Architecture: x86_64/arm64
• OS: Ubuntu 16.04/18.04/20.04
• ROS: Kinetic/Melodic/Noetic

It should also work in other similar Linux environments but only the above listed environments are regularly tested.

Communication protocol

Robot	Protocol V1	Protocol V2	UART	CAN	Support Status
Scout 1.0	Y	-	N	Y	Discontinued
Scout 2.0	Y	Y	N	Y	Active
Scout Mini (Skid)	Y	Y	-	Y	Active
Scout Mini (Omni)	Y	Y	-	Y	Active
Hunter 1.0	Y	Y	-	Y	Active
Hunter 2.0	-	Y	-	Y	Active
Bunker	Y	Y	-	Y	Active
Tracer	-	Y	N	Y	Active
Ranger Mini	-	Y	-	Y	Active

Important Note

The main branch of this repository supports all Scout variants and both V1 and V2 protocol. Earlier versions of the SDK can be found in v1.x and v2.x branch for V1 and V2 protocol support respectively.

• V1 Protocol: v1.x branch of scout_ros and ugv_sdk
• V2 Protocol: v2.x branch of scout_ros and ugv_sdk

Build SDK

Install dependencies

$ sudo apt-get update
$ sudo apt-get install build-essential git cmake libasio-dev

Build the package in catkin workspace

$ cd <your-catkin-ws>/src
$ git clone https://github.com/westonrobot/ugv_sdk.git
$ cd ..
$ catkin_make

Setup CAN-To-USB adapter

1. Enable gs_usb kernel module

   $ sudo modprobe gs_usb
   

2. Bringup can device

   $ sudo ip link set can0 up type can bitrate 500000
   

3. If no error occured during the previous steps, you should be able to see the can device now by using command

   $ ifconfig -a
   

4. Install and use can-utils to test the hardware

   $ sudo apt install can-utils
   

5. Testing command

   # receiving data from can0
   $ candump can0
   # send data to can0
   $ cansend can0 001#1122334455667788
   

Two scripts inside the "./scripts" folder are provided for easy setup. You can run "./setup_can2usb.bash" for the first-time setup and run "./bringup_can2usb.bash" to bring up the device each time you unplug and re-plug the adapter.

Demo Code

You can find demo code for each robot in "demo" folder. For example, run the demo for Scout robot

$ ./bin/demo_scout_robot can0

Reference

• CAN command reference in Linux