PiEEG-Club is a place, where researchers, coders, and any neuroscience enthusiast can share some scripts for PiEEG devices. Make neuroscience available for all
Please be free add your GUI in this repository
Manual
Manual for quick start
https://pieeg.com/
Contact: [email protected]
Connect the shield to Raspberry Pi which is supplied via a 5V battery (power supply) and connect electrodes.
Full galvanic isolation from mains is required.
This also applies to the monitor. Use only a monitor that is powered by the Raspberry Pi, as in the picture below, left. Electrodes are positioned according to the International 10-20 system, right
Warning
PiEEG is not medical device. You are fully responsible for your personal decision to purchase this device and, ultimately, for its safe use. PiEEG is not a medical device and has not been certified by any government regulatory agency for use with the human body. Use it at your own risk.
Caution
The device must operate only from a battery - 5 V. Complete isolation from the mains power is required.! The device MUST not be connected to any kind of mains power, via USB or otherwise.
Power supply - only battery 5V, please read the liability
I. Rakhmatuiln, et all. (2021). Raspberry Pi Shield - for measure EEG (PIEEG). 2021 5th International Conference on Electrical, Electronics, Communication, Computer Technologies and Optimization Techniques (ICEECCOT), 410-413. DOI: 10.1109/ICEECCOT52851.2021.9707969 link
Rakhmatulin, I., Volkl, S. (2020). PIEEG: Turn a Raspberry Pi into a Brain-Computer Interface to measure biosignals. arXiv:2201.02228, https://arxiv.org/abs/2201.02228
