ctlstore is a distributed data store that provides very low latency, always-available, "infinitely" scalable reads. The underlying mechanism for this is a SQLite database that runs on every host called the LDB. A daemon called the Reflector plays logged writes from a central database into the LDB. As this involves replicating the full data store on every host, it is only practical for situations where the write rate (<100/s total) and data volumes (<10GB total) are low.
Recommended reading:
Note that because ctlstore replicates the central database to an LDB on each host with a reflector, that LDB contains all of the control data. In its current state that means that any application which has access to the LDB can access all of the data within it.
The implications of this are that you should not store data in ctlstore that should only be accessed by a subset of the applications that can read the LDB. Things like secrets, passwords, and so on, are an example of this.
The ctlstore system is meant to store non-sensitive configuration data.
A MySQL database is needed to run the tests, which can be started using Docker Compose:
$ docker-compose up -d
Run the tests using make:
$ make test
# For more verbosity (`Q=` trick applies to all targets)
$ make test Q=
A single ctlstore binary is used for all functionality. Build it with make:
$ make build
Sync non-stdlib dependencies and pull them into ./vendor
$ make deps
Ctlstore uses Go modules. To build a docker image, the dependencies must be vendored first:
$ make vendor
Many of ctlstore's unit tests use mocks. To regenerate the mocks using counterfeiter:
$ make generate
This project includes a docker-compose file docker-compose-example.yml. This initializes and runs
- mysql (ctlstore SoR)
- executive service (guards the ctlstore SoR)
- reflector (builds the LDB)
- heartbeat (mutates a ctlstore table periodically)
- sidecar (provides HTTP API access to ctlstore reader API)
- supervisor (periodically snapshots LDB)
To start it, run:
$ make deps
$ make vendor
$ docker-compose -f docker-compose-example.yml up -d