Meant for OpenTabletDriver
Improves cursor clarity for higher refresh rate monitors with minimal latency. It is very effective if your tablet reports at 133rps (ctl-472, ctl-672) and your monitor updates at 240hz.
Prediction Ratio:
Default: 0.5
Range: 0.0 - 1.0
Determines the time distance the filter predicts inputs for each tablet update.
0.0 == [slower] 0% predicted, one rps of latency
0.5 == [balanced] 50% predicted, half rps of latency
1.0 == [overkill] 100% predicted, no added latency (works best with some smoothing)
Follow Radius:
Default: 0.0
Radius of cursor trailing distance in millimeters.
Smoothing Latency:
Default: 0ms
The amount of latency added by smoothing, approach is similar to Hawku smoothing.
Reverse EMA:
Default: 1
Range: 0.0 - 1.0
Removes hardware smoothing, fine-tuned this to your tablet. Follow the guide given in the Reconstructor filter wiki (linked below).
1.0 == no effect
lower == removes more hardware smoothing
Maximize Frequency
Default: True
Wires ConsumeState to UpdateState for a further increased update frequency with no elevated OTD CPU usage.
Disable if any unexpected behavior is happening or you just don't want it on.
Log Stats
Default: False
Logs the time and physical latency in OpenTableDriver Console.
Make sure to disable when you are done so you don't waste memory.
[False] == logging disabled
[True] == logging enabled, check the Console tab in OpenTableDriver