Add Support - MAGICHOME zj-lb-rgbw-i RGBW LED BULB #1674
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
This is adding support for the MAGICHOME zj-lb-rgbw-i LED bulb. This is the 4.5w bulb you will find on Wish, packaged in a blue box labeled wifibulb. I had to dis-assemble the bulb and solder wires to the board to flash it, I could not find a way to flash this one OTA. It does have labeled solder points. There are 2 points labeled ground, I found I needed to use the one closest to the ESP chip. The only way to find out the model number of this bulb is to remove the plastic lens and get out the magnifier to read it off the board.