-
Notifications
You must be signed in to change notification settings - Fork 0
01 Introduction
JonasForssell edited this page Jun 10, 2017
·
3 revisions
Welcome to the HangAround wiki!
HangAround is an ultra low cost 3D printer which has the following goals:
- Total cost is less than 49 Euro
- Few parts
- Easy to assemble
- Large build volume of Dia 400x400 mm
To acheve this, we use low cost geared steppers normally used in appliances such as 28byj-48 The frame is eliminated. Instead the printer is suspended under a table.
The design builds on the fantastic work of the Hangprinter to achieve these goals. Other inspiration comes from the ToyPrinter project.
Look elsewhere if:
- You expect good print quality
- You expect fast prints
- Want to print ABS and other materials that need heated bed
Order parts and start your build if you expect:
- To learn a lot
- To have fun
- To impress friends